Where To Buy
Contact Us
Log In
Subscribe to Newsletter

Orion Signal Extension Cable

The Orion series cables are a commercial grade solution for mobile or permanent wiring in harsh conditions. The IP68 connectors, used with our Twilight fixtures, offer the same quality watertight connector as our luminaires.

Models

  • VVD11908FR – 3’ IP68 DMX Cable
  • VVD11909FR – 6’ IP68 DMX Cable
  • VVD11910FR – 10’ IP68 DMX Cable
  • VVD11911FR – 17‘ IP68 DMX Cable
  • VVD11912FR – 33’ IP68 DMX Cable
  • VVD11913FR – 50‘ IP68 DMX Cable
  • VVD11915FR – 65’ IP68 DMX Cable
  • VVD11916FR – 80’ IP68 DMX Cable
  • VVD11917FR – 100’ IP68 DMX Cable
  • VVD11914FR – IP68 DMX Terminator Male
  • VVDMFENDS68FR – DMX IP68 Connectors (For Bulk Cable – Pair M/F)
  • VVDDMXBLKFR – Indoor/Outdoor Bulk DMX Cable – sold by the foot  
  • VVDCONVERTFR – DMX IP68 to IP20 XLR 1’ Converter Cable (Pair M/F)
  • VVD21908FR – 3’ IP68 0-10V Cable
  • VVD21909FR – 6’ IP68 0-10V Cable
  • VVD21910FR – 10’ IP68 0-10V Cable
  • VVD21911FR – 17‘ IP68 0-10V Cable
  • VVD21912FR – 33’ IP68 0-10V Cable
  • VVD21913FR – 50‘ IP68 0-10V Cable
  • VVD21915FR – 65’ IP68 0-10V Cable
  • VVD21916FR – 80’ IP68 0-10V Cable
  • VVD21917FR – 100’ IP68 0-10V Cable
  • VVDMFENDS69FR – 0-10V IP68 Connectors (For Bulk Cable – Pair M/F)
  • VVD010BLKFR – Indoor/Outdoor Bulk 0-10V Cable – sold by the foot 
  • Commercial grade DMX or 0-10V cables for RGB fixtures
  • DMX cable is 22AWG, UL2464, 128net, 3-pin in a black insulated sleeve
  • DMX cable rated at 80 cegrees Celsius, 300VW-1, 6mm connector diameter
  • O-10V cable is 18AWG, SVT temperature resistant, 2-pin in a black insulated sleeve
  • 0-10V cable rated at 105 degrees Celsius, copper core, 7mm connector diameter
  • Specifically designed for any professional lighting control setup
  • IP68 features quality PVC LLT twist-lock connectors
  • All cable lengths are male to female with included connector
  • A terminator is suggested for the end of the DMX fixture run
  • Maximum DMX run is 300’ or 60 fixtures and signal amplifiers are available for extended runs.
  • Maximum 0-10V run is 300’. Caution should be taken not to run the cable near the power cable to avoid interference.
  • For outdoor use, it is recommended to heat shrink over all connectors for a long life installation.
  • A DMX terminator should be used to terminate the last fixture.
  • Check local building and electrical codes before assuming these cables can be used for your project.

Spec Sheet